If you ever had the necessity to capture HDMI to USB, you’ll know that nowadays there are cheap HDMI to USB capture dongles available in Amazon, Aliexpress or Ebay, that allow to record your HDMI stream to your PC, using OBS or even VLC. Be aware that most of these dongles are advertised as USB 3.0, but instead they are USB 2.0 only, so forget about 1080p @60Hz. Still, USB 2.0 is enough for some applications. These cards are sold under 15$, so, despite they are USB 2.0, they are worth a try.
However, if you need to capture a VGA signal (like we did, to capture uSVC images), the situation is completely different. There are some VGA to USB dongles, or other VGA capture cards, but these are overly expensive, well above 100$ (sometimes above 200$) and some of them have a noticeable lag between input and output.
This article is different from the ones we used to write: in this hack, we won’t create anything from scratch, but instead, we will show a simple trick that allows you to reduce the cost of your VGA acquisition system by a factor 5 at least. Furthermore, you’ll get a more versatile equipment.
A very simple hack
We already wrote that you can find cheap HDMI to USB capture cards (note! HDMI -> USB, not the opposite, which is useless for this hack!). The trick is simple: buy one of these adapters, and also buy a VGA to HDMI adapter (note: VGA -> HDMI, not the opposite, which is useless for this hack!). You’ll also need to get an HDMI cable too (of whatever length) if you don’t have one spare.
There are many VGA to HDMI adapters, but if you can afford some 8$ extra, we recommend buying one that also has an additional VGA output. It is always useful to see in an actual monitor what you are recording, without having to check the recording software window on the PC screen.
Therefore, instead of having to purchase a VGA capture device (which can only do just that job), you need to buy:
- The HDMI to USB capture dongle – about 13$
- An HDMI cable (if you don’t have it already) – about 1$
- A VGA to HDMI converter – about 3$. We bought this one, which is more expensive but it has an additional VGA output, if you want to connect a monitor too. – about 11$
- If you buy the cheapest VGA to HDMI converter, you might need a VGA male to male cable too like this one (about 3$).
Then, just make the connection:
VGA OUTPUT to be recorded -> VGA TO HDMI CONVERTER -> HDMI CAPTURE CARD -> USB of your PC/MAC and you’re set.
This is our setup to capture the VGA output of our DIY VGA console. Yes, it is quite a mess of cables, but it does the job quite nicely!
Configuring OBS to Capture the Video
To capture the actual video data:
- Download and install OBS
- Connect everything as written above
- Launch OBS
- Under “Sources”, click on “+”
- On the menu, find and select “Video capture device”
- On the “Create/Select Source” window, click on “create new”, and press OK.
- Choose the device from the drop down list. In our case it was named “USB Video”. Also choose the resolution and FPS type. Once the parameters are configured correctly, you should already see the preview.
You should spend no more than 20-28$ (including shipping) for not only a system that allows you to capture a VGA signal, but also:
- Has also an HDMI capture device.
- Has also a VGA to HDMI converter.
- (if you purchase the VGA->HDMI converter with an additional VGA output) It allows to show the same image in two monitors (one VGA and one HDMI).
And what about lag? 20ms!
Not bad for 20$, isn’t it?